Pelletboiler 30kW black

Automatic Sub-Pressure Wood Pellet Boiler 30kW
Dimensions (WxHxD) 1144x694x1485mm
Centralheating system connection - 1 1/4"
Flue outlet height - 975mm
Flue outlet diameter - 120mm
Weight - 338kg
Output - 9,5-31,7kW
Fluegas temperature max - 160°C
Capacity of the fuel tank - 150kg
Fuel consumption 2,18-7,17kg/h
Diameter of the external air intake - 50mm
Voltage/frequency 220V/50Hz
Boiler volume 80l
This boiler is designed to combust fuel made of pressed wood mass (pellets with a diameter of 6 mm to 7 mm, length 
of about 30 mm and maximum moisture of 8-9%)

TOBY represents one of the most sophisticated solutions for automatic combustion of wood pellets to be found on the market.
It is completely adapted to burn wood pellet as a primary fuel, achieving maximum efficiency level up to 94% and a very low exit temperature for flue gases (below 160 °C).
Ignition, start-up and turning-off are fully automatized. Combustion control is optimized using algorithms such as ‘modulation’ which automatically decreases pellet dose as the difference between desired and reached temperature is decreasing. Boiler regulation is via touch screen panel.
Working principle of this boiler is based on the “sub-pressure” of the heating chamber. The chamber is completely air-proof so that air flow in the boiler is fully controlled by the exhaust fan mounted on the back. Boiler regulation completely controls the quantity of the air inside the heating chamber: optimum combustion comes as a result.
Boiler chamber is made by welding 5mm thick steel plates (all surfaces in touch with fire). Other parts are made of 4mm steel.
The efficiency of this boiler is much higher than that of the conventional boilers with natural air flow.
Pellets are fed to boiler via internal transporter screw inside the storage tank. From there pellets are fed over to heating chamber where they fall free to the designated melting area (the ‘actual’ embedded burner of the boiler). Storage and melting area are physically divided. There is a safety thermostat to prevent back-fire. There is also a pressure sensor inside the heating chamber – when the boiler door is open, this sensor will react and stop the feeding process. There is also an anti-explosion safety door on the side of the heating chamber.
Maintenance and cleaning are reduced to a minimum compared to all solid fuel boilers – only once a week, if not less than that, with premium quality pellet and proper use following the guidelines.